On the Spectrum 3D example in the Demo application, I'm trying to duplicate some of this behavior. I'm wondering if there is a way to not show/render an area that hasn't been filled yet. So the area marked by red in the image below would not render.
I tried changing the range of z, but that didn't seem to work.
Spectrum 3D don't show unfilled data
Moderator: Queue Moderators
- ArctionPasi
- Posts: 1367
- Joined: Tue Mar 26, 2013 10:57 pm
- Location: Finland
- Contact:
Re: Spectrum 3D don't show unfilled data
The easiest way to handle this is to set
m_surface.InitialValue = -10; //below Y axis minimum
and set 3D clipping:
m_chart.View3D.ClipContents = true;
Then it won't show the surface at -10 level.
To improve performance, disable ClipContents when a full range of data has been collected.
m_surface.InitialValue = -10; //below Y axis minimum
and set 3D clipping:
m_chart.View3D.ClipContents = true;
Then it won't show the surface at -10 level.
To improve performance, disable ClipContents when a full range of data has been collected.
LightningChart Support Team, PT